Aftertreatment DEF Pump Reversing Valve - Not Responding
What does CUMMINS-2676 mean?
The CUMMINS-2676 (Cummins) diesel fault code means: Aftertreatment DEF Pump Reversing Valve - Not Responding. This is a moderate severity code.
Common Symptoms
- DEF warning lamp illuminated
- Countdown to engine derate (typically 50 hours)
- Low DEF or poor DEF quality warnings
- SCR efficiency drops (NOx emissions up)
- Possible 5 mph limp mode if ignored
Probable Causes (Ranked by Likelihood)
- Contaminated or watered-down DEF Very Likely
- Failed DEF pump or dosing module Likely
- Clogged DEF doser nozzle (urea crystallization) Likely
- Failed DEF quality or level sensor Possible
- DEF tank heater failed (frozen DEF) Possible
- Corroded DEF supply module harness Less Likely
Step-by-Step Diagnostic Procedure
Connect INSITE and verify DEF pump pressure builds to spec (around 70-130 psi) during dosing test.
Check DEF quality with a refractometer -- must read 32.5% urea concentration. Replace contaminated DEF.
Inspect DEF doser nozzle tip for urea crystallization -- clean with distilled water, do not use solvents.
Measure DEF tank level and temperature via INSITE; replace failed temp or level sensor if erratic.
Inspect DEF supply lines for kinks, leaks, or crystallization at joints.
If pump fails dosing test for 2676, rebuild or replace DEF pump module and reprime the system via INSITE.
Frequently Asked Questions
What is Cummins fault code 2676?
Cummins fault code 2676 indicates: Aftertreatment DEF Pump Reversing Valve - Not Responding. It is a moderate-severity fault in the aftertreatment or emissions system.
Can I drive with Cummins fault code 2676?
Yes, short-term driving is typically safe with fault 2676, but the fault will illuminate the Check Engine Light and must be diagnosed soon. Monitor for power loss, unusual noises, or gauge changes and pull over if conditions worsen.
How much does it cost to fix Cummins fault 2676?
Repair cost is approximately $400-$1,500 including parts, labor, and any dealer programming required. DIY repairs (sensor replacement) fall at the low end; pump, aftertreatment, or ECM work falls at the high end and usually requires INSITE diagnostic software.