P0202 serious

Injector Circuit Malfunction - Cylinder 2

The P0202 code means the vehicle's onboard diagnostic system has detected: Injector Circuit Malfunction - Cylinder 2. This is a serious severity code.

My Garage →
Keep driving?
Yes, but fix soon
DIY difficulty
medium
Estimated cost
$25-$400
Recommended Tool
ANCEL AD310 OBD-II Scanner

Best-selling code reader on Amazon. Reads and clears check engine codes on any 1996+ vehicle. Under $30.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Every Tech Needs This
AstroAI Digital Multimeter

Essential for diagnosing sensor codes, checking voltage, and testing circuits. Under $15 and pays for itself on the first job.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Common Symptoms

  • Check Engine Light on
  • Cylinder 2 misfire
  • Rough idle
  • Loss of power
  • Fuel odor

Probable Causes (Ranked by Likelihood)

  • Open or short in cylinder 2 injector wiring Very High
  • Failed cylinder 2 injector High
  • Corroded injector connector High
  • PCM driver failure for cylinder 2 Moderate

Step-by-Step Diagnostic Procedure

  1. Use NOID light on cylinder 2 injector connector while cranking.

  2. Measure cylinder 2 injector resistance.

  3. Check wiring continuity from injector harness to PCM.

  4. Perform injector balance test if scan tool supports it.

Common Fixes by Vehicle

What techs usually find when diagnosing P0202 on specific vehicles — tap your vehicle for the fix and the exact part:

2009-2020 Ford F-150/Explorer 3.5L/5.0L Moderate DIY

Cylinder 2 injector circuit malfunction. Test injector resistance at the connector (should be 11-15 ohms). If resistance is normal, check the wiring harness between the PCM and injector for an open circuit. On the 5.0L Coyote, the injector wiring harness runs under the intake manifold and can chafe. Swap the injector with another cylinder to isolate.

Labor: 1-2 hours
2010-2020 Chevrolet Silverado/GMC Sierra 5.3L Moderate DIY

Cylinder 2 injector circuit fault. Measure injector coil resistance (11-13 ohms expected). If injector tests good, check the wiring from the ECU. On the 5.3L, the injector harness connectors can work loose from engine vibration. Ensure the connector is fully seated and locked. Replace with ACDelco 217-3449 if the injector coil is open.

Labor: 1-1.5 hours
2007-2017 Toyota Camry/RAV4 2.5L Moderate DIY

Injector 2 circuit open or shorted. Check the injector connector for corrosion or loose pins. Measure resistance (11-16 ohms). If the injector is good, trace the wiring to the ECU. On the 2AR-FE, the injector connectors can get oil-soaked from valve cover gasket leaks which causes corrosion. Clean and replace the connector if damaged.

Labor: 1-1.5 hours

Frequently Asked Questions

Can a leaking injector on cylinder 2 cause P0202?

Not directly. P0202 is a circuit fault (wiring or driver issue). A leaking injector would cause a rich condition and possibly P0172 or a misfire code. A failed/open injector can cause both P0202 and P0302.

Sources

This page is built from documented references. Verify against your own service info before repair work.

P0202 on Diesel, EV & Equipment

The same code ID appears across other engines and platforms. The diagnostic flow varies by manufacturer — these are the platform-specific breakdowns:

See All Codes & Fixes for Your Vehicle

Explore More

Was this helpful?

Share carcodefinder.com with a friend who needs to decode their check engine light.