Fuel Volume Regulator Control Circuit Range/Performance
The P0002 code means the vehicle's onboard diagnostic system has detected: Fuel Volume Regulator Control Circuit Range/Performance. This is a moderate severity code.
- Keep driving?
- Short distances only
- DIY difficulty
- hard
- Estimated cost
- $100 - $550 (parts and labor)
Best-selling code reader on Amazon. Reads and clears check engine codes on any 1996+ vehicle. Under $30.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Essential for diagnosing sensor codes, checking voltage, and testing circuits. Under $15 and pays for itself on the first job.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Common Symptoms
- Check Engine Light on
- Rough idle
- Poor acceleration
- Engine surging at steady speed
Probable Causes (Ranked by Likelihood)
- Fuel volume regulator not responding within expected range Very High
- Partially clogged fuel filter restricting flow High
- Intermittent wiring fault in regulator circuit Moderate
- Weak high-pressure fuel pump Moderate
Step-by-Step Diagnostic Procedure
-
Monitor actual vs commanded fuel rail pressure with a scan tool during idle and acceleration
-
Inspect the fuel volume regulator connector for backed-out pins or intermittent contact
-
Check fuel filter service history and replace if overdue
-
Test fuel volume regulator resistance and compare to spec; check for drift when heated
Frequently Asked Questions
What is the difference between P0001 and P0002?
P0001 indicates an open circuit to the fuel volume regulator, meaning no electrical signal is reaching it. P0002 means the circuit is working but the regulator output is outside the expected range, suggesting a performance issue rather than a complete electrical failure.
Can a clogged fuel filter cause P0002?
Yes. A restricted fuel filter limits the fuel volume the pump can deliver, causing the regulator to operate outside its expected performance range as it tries to compensate for reduced flow.
Will P0002 cause my engine to stall?
It can. If the fuel volume regulator cannot maintain proper fuel delivery, the engine may stall at idle or under load, especially during cold starts when fuel demand patterns change.
Sources
This page is built from documented references. Verify against your own service info before repair work.
Explore More
Was this helpful?
Share carcodefinder.com with a friend who needs to decode their check engine light.