C0095 moderate

Brake Pedal Position Sensor Circuit Malfunction

The C0095 code means the vehicle's onboard diagnostic system has detected: Brake Pedal Position Sensor Circuit Malfunction. This is a moderate severity code.

My Garage →

Keep driving?: Short distances only
DIY difficulty: moderate
Estimated cost: $20 - $200 (parts and labor)

Read ABS Codes

BlueDriver Bluetooth Pro Scanner

Basic scanners cannot read ABS codes. BlueDriver reads all systems including ABS, SRS, and transmission through your phone.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Read ABS Codes

LAUNCH CRP123X (Reads ABS + Chassis)

Basic scanners cannot read ABS codes. This one reads all four systems so you know exactly which sensor failed.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Common Symptoms

Brake lights stay on or do not come on
Cruise control will not set or hold
Electronic stability control warning
Brake-throttle override not functioning
Shift interlock stuck or intermittent

Probable Causes (Ranked by Likelihood)

Failed brake pedal position sensor or switch Very High
Misadjusted brake light switch High
Broken brake pedal switch stopper pad Moderate
Wiring issue at brake pedal switch Low

Step-by-Step Diagnostic Procedure

Check brake lights for proper on/off operation
Inspect brake pedal switch stopper pad for deterioration
Read brake pedal position with scan tool
Adjust or replace brake light switch
Test switch continuity with multimeter

Frequently Asked Questions

What is a brake pedal stopper pad?

It is a small rubber or plastic bumper on the brake pedal arm that contacts the brake light switch. When it breaks, the pedal pushes the switch too far, causing brake lights to stay on.

Why does cruise control stop working with a brake switch issue?

Cruise control uses the brake switch signal to deactivate when the brake is pressed. If the switch is faulty, the system may think the brake is always applied and refuse to engage.

Is the stopper pad a common failure?

Yes. The stopper pad is a very common failure, especially on Toyota and Lexus vehicles. It is an inexpensive part and easy to replace, usually without any tools.