P2419 low

EVAP System Switching Valve Control Circuit Low

The P2419 code means the vehicle's onboard diagnostic system has detected: EVAP System Switching Valve Control Circuit Low. This is a low severity code.

My Garage →
Keep driving?
Yes, but fix soon
DIY difficulty
moderate
Estimated cost
$75 - $350 (parts and labor)
ANCEL AD310 OBD-II Scanner
Recommended Tool
ANCEL AD310 OBD-II Scanner

Best-selling code reader on Amazon. Reads and clears check engine codes on any 1996+ vehicle. Under $30.

Check Price on Amazon
AstroAI Digital Multimeter
Every Tech Needs This
AstroAI Digital Multimeter

Essential for diagnosing sensor codes, checking voltage, and testing circuits. Under $15 and pays for itself on the first job.

Check Price on Amazon

Affiliate links — we earn a commission at no extra cost to you.

What Are the Symptoms of P2419?

  • Check Engine Light on
  • Failed emissions test
  • No drivability issues
  • EVAP readiness monitor incomplete
  • Fuel vapor smell possible near engine

What Causes P2419? (Most Likely First)

  • Short to ground in EVAP valve wiring Very High
  • Failed EVAP switching valve (shorted coil) High
  • Corroded valve connector with low resistance Moderate
  • ECM driver circuit fault Low

Can I Still Drive with P2419?

Yes, but fix soon. P2419 is rated low severity. It is not an immediate stop-driving fault, but it will not clear itself — book the repair rather than ignoring the light.

Frequently Asked Questions

Can I drive with code P2419?

Yes, safe to drive. This emissions code does not affect engine performance or vehicle safety.

What causes P2419?

Usually a shorted EVAP solenoid or wiring that has been damaged. The solenoid is an inexpensive and easy-to-replace part.

Is P2419 expensive to fix?

Typically $75 to $350. Solenoid replacement is the most common and affordable repair.

Mechanics Guide Step-by-step diagnosis

How Do You Diagnose P2419?

  1. Measure EVAP valve solenoid resistance (compare to specification)

  2. Check wiring for short to ground between ECM and valve

  3. Inspect valve connector for corrosion or water damage

  4. Command valve operation with scan tool and verify response

  5. Check for voltage at valve connector

Sources 2

This page is built from documented references. Verify against your own service info before repair work.

Which Vehicles Commonly Get P2419?

  • 2012-2020 Subaru Legacy
  • 2013-2021 Toyota RAV4
  • 2014-2022 Honda Accord
  • 2011-2019 Mazda3

Explore More

Was this helpful?

Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.