P2147 low

Throttle/Pedal Position Sensor/Switch A Circuit Low

The P2147 code means the vehicle's onboard diagnostic system has detected: Throttle/Pedal Position Sensor/Switch A Circuit Low. This is a low severity code.

My Garage →

Keep driving?: Yes, but fix soon
DIY difficulty: moderate
Estimated cost: $80 - $400 (parts and labor)

Recommended Tool

ANCEL AD310 OBD-II Scanner

Best-selling code reader on Amazon. Reads and clears check engine codes on any 1996+ vehicle. Under $30.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Every Tech Needs This

AstroAI Digital Multimeter

Essential for diagnosing sensor codes, checking voltage, and testing circuits. Under $15 and pays for itself on the first job.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Common Symptoms

Check Engine Light on
Reduced engine power warning
Erratic throttle response
Engine may enter limp mode
Poor acceleration

Probable Causes (Ranked by Likelihood)

Short to ground in TPS A circuit Very High
Failed TPS A with low output High
Wiring shorted to engine ground Moderate
ECM input shorted Low

Step-by-Step Diagnostic Procedure

Read TPS A voltage on scan tool at closed and wide open throttle
Inspect TPS A wiring and connector
Measure TPS A reference voltage (should be approximately 5V)
Compare TPS A to TPS B readings for correlation

Frequently Asked Questions

What does P2147 mean?

P2147 indicates: Throttle/Pedal Position Sensor/Switch A Circuit Low. The ECM detected an abnormal condition in this sensor circuit.

Is P2147 serious?

Low severity, but should be repaired to maintain proper engine management.

What should I check first?

Start with a visual inspection of the sensor wiring and connector. Use a scan tool to read sensor data and compare to expected values. Check reference voltage (typically 5V) at the sensor connector.