P2134 moderate

Throttle/Pedal Position Sensor/Switch F Circuit Intermittent

The P2134 code means the vehicle's onboard diagnostic system has detected: Throttle/Pedal Position Sensor/Switch F Circuit Intermittent. This is a moderate severity code.

My Garage →

Keep driving?: Short distances only
DIY difficulty: moderate
Estimated cost: $100 - $600 (parts and labor)

Recommended Tool

ANCEL AD310 OBD-II Scanner

Best-selling code reader on Amazon. Reads and clears check engine codes on any 1996+ vehicle. Under $30.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Every Tech Needs This

AstroAI Digital Multimeter

Essential for diagnosing sensor codes, checking voltage, and testing circuits. Under $15 and pays for itself on the first job.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Common Symptoms

Intermittent reduced power events
Occasional throttle hesitation
Sporadic idle fluctuations
Code sets and clears on its own
Check engine light on intermittently

Probable Causes (Ranked by Likelihood)

Intermittent connection at throttle body connector Very High
TPS F sensor failing intermittently (internal wear) High
Wiring with intermittent break near throttle body Moderate
Vibration-induced connector disconnection Moderate
Heat-related sensor intermittent failure Low

Step-by-Step Diagnostic Procedure

Monitor TPS F signal while wiggling the throttle body connector -- look for signal dropout
Graph TPS F voltage during a drive -- watch for random spikes or dropouts
Inspect throttle body connector locking tab and terminals for secure fit
Flex wiring near throttle body while monitoring signal
Replace throttle body if intermittent fault is confirmed internal to the sensor

Frequently Asked Questions

Can I drive with code P2134?

You can drive short distances, but be aware that reduced power mode may activate unpredictably. This makes the vehicle unreliable in traffic situations where consistent throttle response is needed.

Why does this code come and go?

Intermittent TPS faults are caused by connections that lose contact briefly due to vibration, temperature changes, or a sensor element that is partially worn. The fault occurs momentarily then resolves, making diagnosis challenging.

How do I catch an intermittent TPS fault?

Use a scan tool to graph or record TPS F voltage over a drive cycle. The intermittent fault will show as a sudden spike or dropout in the voltage trace. A wiggle test at the connector can also reproduce the fault if the connection is the problem.