Intake Manifold Runner Control Circuit Open (Bank 1)
The P2008 code means the vehicle's onboard diagnostic system has detected: Intake Manifold Runner Control Circuit Open (Bank 1). This is a moderate severity code.
- Keep driving?
- Short distances only
- DIY difficulty
- moderate
- Estimated cost
- $100 - $400 (parts and labor)
Best-selling code reader on Amazon. Reads and clears check engine codes on any 1996+ vehicle. Under $30.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Essential for diagnosing sensor codes, checking voltage, and testing circuits. Under $15 and pays for itself on the first job.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Common Symptoms
- Check Engine Light on
- Reduced engine performance
- Poor throttle response
- Rough idle condition
- Decreased fuel economy
Probable Causes (Ranked by Likelihood)
- Open circuit in runner control solenoid wiring Very High
- Failed intake manifold runner control solenoid High
- Corroded or damaged connector Moderate
- Blown fuse for runner control circuit Moderate
- PCM driver circuit failure Low
Step-by-Step Diagnostic Procedure
-
Confirm P2008 with freeze frame data
-
Check fuse and power supply to the runner control solenoid
-
Inspect wiring harness and connector for damage, corrosion, or open circuits
-
Measure solenoid resistance and compare to specifications
Common Fixes by Vehicle
What techs usually find when diagnosing P2008 on specific vehicles — tap your vehicle for the fix and the exact part:
2005-2014 VW Jetta/Passat 2.5L I5 easy DIY
Check IMRC actuator connector at driver side of intake. VW 2.5L harness chafes against valve cover bolts causing open-circuit fault. Repair wiring with solder + shrink. If wiring is good, replace actuator with OEM VW.
Labor: 1 hour2006-2014 Chevy Impala/Malibu 3.5L/3.9L easy DIY
Replace IMRC solenoid on top of intake manifold. GM 3.5/3.9 V6 solenoid fails from heat. Verify wiring has 12V key-on at connector. Use AC Delco part only.
Labor: 30 min2010-2017 Hyundai/Kia 2.4L Theta II (Sonata, Optima, Santa Fe) moderate DIY
Replace IMT (Intake Manifold Tuning) actuator. Hyundai/Kia 2.4L actuator fails open, setting P2008. Check for oil contamination in the actuator bore first. Use Mobis OEM part; aftermarket fails within months.
Labor: 1 hourFrequently Asked Questions
What does P2008 mean?
P2008 indicates an open circuit in the intake manifold runner control solenoid circuit on Bank 1, meaning the PCM cannot control the runner flaps due to an electrical fault.
Can I drive with a P2008 code?
You can drive short distances, but engine performance will be reduced. The runner flaps will default to one position without electrical control.
How much does it cost to fix P2008?
Repairs typically range from $100 to $400. A wiring repair is inexpensive, while a solenoid replacement costs more.
Sources
This page is built from documented references. Verify against your own service info before repair work.
Explore More
Was this helpful?
Share carcodefinder.com with a friend who needs to decode their check engine light.