P0898 moderate

Transmission Control System MIL Request

The P0898 code means the vehicle's onboard diagnostic system has detected: Transmission Control System MIL Request. This is a moderate severity code.

My Garage →

Keep driving?: Short distances only
DIY difficulty: hard
Estimated cost: $100 - $800 (parts and labor)

Check Your Fluid First

ANCEL AD310 OBD-II Scanner

Read and clear transmission codes. Many trans codes are caused by low or burnt fluid -- check level and color before assuming the worst.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Read Transmission Codes

LAUNCH CRP123X (Reads All Systems)

Basic scanners only read engine codes. This reads transmission, ABS, and airbag too.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Common Symptoms

Check Engine Light on
TCM requesting Check Engine Light
Shift quality issues
Erratic transmission behavior

Probable Causes (Ranked by Likelihood)

TCM has detected a condition requiring driver notification Very High
Corroded or damaged wiring connections High
Low battery voltage affecting TCM operation Moderate
TCM internal circuit failure Low

Step-by-Step Diagnostic Procedure

Use a scan tool to read Transmission Control System MIL Request data
Check TCM power supply and ground connections for proper voltage and continuity
Inspect TCM relay and related fuses
Verify battery and charging system health with a multimeter

Frequently Asked Questions

What does P0898 indicate?

P0898 indicates a problem with the transmission control system mil request. This affects TCM operation and may cause shift quality issues.

Can a weak battery cause this code?

Yes. TCM modules are sensitive to voltage supply quality. A weak battery, poor connections, or charging system issues can cause various TCM power-related codes. Always test the battery and charging system first.

Do I need a TCM replacement?

Not necessarily. Most TCM codes are caused by external issues like power supply problems, relay failures, or wiring faults. A TCM replacement is typically only needed when all external causes have been ruled out.