P0613 critical

TCM Processor

The P0613 code means the vehicle's onboard diagnostic system has detected: TCM Processor. This is a critical severity code.

My Garage →

Keep driving?: No -- stop driving
DIY difficulty: hard
Estimated cost: $100 - $800 (parts and labor)

Check Your Fluid First

ANCEL AD310 OBD-II Scanner

Read and clear transmission codes. Many trans codes are caused by low or burnt fluid -- check level and color before assuming the worst.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Read Transmission Codes

LAUNCH CRP123X (Reads All Systems)

Basic scanners only read engine codes. This reads transmission, ABS, and airbag too.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Common Symptoms

Check Engine Light on
Transmission not shifting properly
Vehicle may enter limp mode
Possible no-start condition

Probable Causes (Ranked by Likelihood)

Failed transmission control module processor Very High
Wiring damage or corrosion in the circuit High
Poor electrical connection at module or component Moderate
ECM or control module internal failure Low

Step-by-Step Diagnostic Procedure

Use a scan tool to read data related to TCM Processor
Inspect all related wiring, connectors, and grounds for damage, corrosion, or loose connections
Measure circuit voltage, resistance, and continuity to identify the fault type
Check for technical service bulletins related to this code for your specific vehicle

Common Fixes by Vehicle

What techs usually find when diagnosing P0613 on specific vehicles — tap your vehicle for the fix and the exact part:

2006-2014 Chrysler/Dodge/Jeep 3.6L Pentastar hard DIY

P0613 is TCM internal processor fault -- usually requires TCM replacement + reflash. Chrysler TCM is under the battery tray on most applications. Check for water intrusion (battery tray commonly leaks). If water damage, dry out and retry; if not, replace via dealer or with OEM reflashed unit.

Labor: 2-3 hours

Common fix part Dielectric Grease TCM Pins View on Amazon→

2010-2018 Ford Fusion/Escape 6F35 Transmission moderate DIY

P0613 on Ford 6F35 usually points to TCM internal fault from water in the transmission. Check PCM/TCM connector on transmission for moisture (common issue). Drain and refill with Mercon LV, replace internal filter. If still coded, TCM replacement needed.

Labor: 2 hours

Common fix part Motorcraft Mercon LV ATF View on Amazon→ Compare fitment at PartsGeek→

2007-2015 GM 6L80/6L90 Equipped Trucks hard DIY

Check ground G101 at back of cylinder head -- GM ground strap corrosion mimics internal TCM fault. Clean and re-torque ground. If clean and code returns, TCM (integrated into valve body) may need replacement -- requires pan drop and transmission programming.

Labor: 3 hours

Common fix part ACDelco Ground Strap View on Amazon→ Compare fitment at PartsGeek→

Frequently Asked Questions

What does P0613 mean?

P0613 indicates a fault in the tcm processor. This is an electronic control system code that affects the ECM's ability to manage the associated component or system.

Is P0613 a serious code?

Yes, this code indicates a critical control circuit issue that can affect vehicle operation and should be addressed immediately.

Can a low battery cause ECM-related codes?

Yes. Low battery voltage can cause various ECM and module communication codes. Always verify the battery is fully charged and the charging system is working before diagnosing electronic control module codes.