P0073 low

Ambient Air Temperature Sensor Circuit High

The P0073 code means the vehicle's onboard diagnostic system has detected: Ambient Air Temperature Sensor Circuit High. This is a low severity code.

My Garage →
Keep driving?
Yes, but fix soon
DIY difficulty
easy
Estimated cost
$30 - $200 (parts and labor)
Recommended Tool
ANCEL AD310 OBD-II Scanner

Best-selling code reader on Amazon. Reads and clears check engine codes on any 1996+ vehicle. Under $30.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Every Tech Needs This
AstroAI Digital Multimeter

Essential for diagnosing sensor codes, checking voltage, and testing circuits. Under $15 and pays for itself on the first job.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Common Symptoms

  • Check Engine Light illuminated
  • Dashboard temperature display reads extremely cold or shows dashes
  • Automatic climate control defaults to manual mode
  • Slight cold-start fueling inaccuracy

Probable Causes (Ranked by Likelihood)

  • Open circuit in sensor wiring Very High
  • Failed ambient air temperature sensor (open internally) High
  • Disconnected or corroded sensor connector Moderate
  • PCM internal pull-up resistor fault Low

Step-by-Step Diagnostic Procedure

  1. Read ambient air temp sensor on scan tool. A reading at the minimum (e.g., -40F/-40C) confirms a high circuit (open) condition.

  2. Inspect the sensor connector behind the front bumper. Look for broken pins, corrosion, or a disconnected plug.

  3. Measure sensor resistance: an open reading (infinite ohms) confirms a failed sensor.

  4. Check wiring continuity from the sensor connector to the PCM. Repair any open circuits found.

Frequently Asked Questions

What does circuit high mean for P0073?

Circuit high means the PCM is seeing a voltage above the normal range. For this sensor, it usually indicates an open circuit where no signal is reaching the PCM.

Could a bumper replacement cause P0073?

Yes, if the ambient air temperature sensor was not reconnected after bumper removal, or if the wiring was damaged during the repair, P0073 will set.

Is P0073 an emissions failure?

Yes, the illuminated Check Engine Light will cause an emissions test failure regardless of the severity of the code.

Sources

This page is built from documented references. Verify against your own service info before repair work.

Explore More

Search codes Vehicle-specific fixes Guides By make

Was this helpful?

Share carcodefinder.com with a friend who needs to decode their check engine light.

Browse by symptom → Read repair guides → Fixes by vehicle →