C0141 critical

Left Front ABS Inlet Valve Solenoid Malfunction

The C0141 code means the vehicle's onboard diagnostic system has detected: Left Front ABS Inlet Valve Solenoid Malfunction. This is a critical severity code.

My Garage →

Keep driving?: Short distances only
DIY difficulty: hard
Estimated cost: $400 - $1500 (parts and labor)

Read ABS Codes

BlueDriver Bluetooth Pro Scanner

Basic scanners cannot read ABS codes. BlueDriver reads all systems including ABS, SRS, and transmission through your phone.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Read ABS Codes

LAUNCH CRP123X (Reads ABS + Chassis)

Basic scanners cannot read ABS codes. This one reads all four systems so you know exactly which sensor failed.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Common Symptoms

ABS warning light on
Left front wheel locks during ABS braking
Uneven braking feel
Traction control disabled
Vehicle pulls left during hard braking

Probable Causes (Ranked by Likelihood)

Failed ABS inlet valve solenoid Very High
Contaminated brake fluid clogging the valve High
ABS modulator internal electrical fault Moderate
Debris in ABS hydraulic passages Moderate
ABS control module driver circuit failure Low

Step-by-Step Diagnostic Procedure

Scan for DTCs and monitor ABS valve activation in live data
Perform an ABS automated bleed to check valve operation
Check brake fluid for contamination or debris
Listen for solenoid clicking during ABS self-test at startup
Test solenoid coil resistance if accessible through the module connector

Frequently Asked Questions

What does the ABS inlet valve do?

The ABS inlet valve controls brake fluid flow into the wheel brake caliper. During ABS activation, it closes to prevent additional fluid pressure from reaching the wheel, helping to prevent wheel lockup.

Can the inlet valve be replaced separately?

On most vehicles, the solenoid valves are integrated into the ABS hydraulic modulator and cannot be individually replaced. The entire modulator assembly typically needs to be replaced.

Can contaminated brake fluid damage ABS valves?

Yes. Moisture-contaminated or old brake fluid can cause internal corrosion and debris that clogs the tiny passages in ABS solenoid valves. Regular brake fluid changes every 2-3 years help prevent this.