Español
VOLVO-MACK-MID216-PID177-FMI4 moderate Volvo/Mack D/MP Series ›

Transmission Oil Temperature Voltage Below Normal

My Garage →
Can I Drive?
Yes, But Fix Soon
DIY Difficulty
advanced
Estimated Cost
$400-$3,500

What does VOLVO-MACK-MID216-PID177-FMI4 mean?

The VOLVO-MACK-MID216-PID177-FMI4 (Volvo/Mack D/MP Series) diesel fault code means: Transmission Oil Temperature Voltage Below Normal. This is a moderate severity code.

Common Symptoms

  • Transmission warning lamp illuminated
  • Harsh or missed shifts (I-Shift/mDRIVE)
  • Neutral lockout or limp-home mode
  • Engine will not start (neutral safety fault)
  • Check Engine Light with trans fault code

Probable Causes (Ranked by Likelihood)

  • Failed trans oil temp sensor Likely
  • Wiring harness damage at transmission connector Likely
  • Low transmission oil level or wrong fluid type Possible
  • Clutch wear (for clutch actuator codes) out of adjustment range Possible
  • TCM internal fault Less Likely

Step-by-Step Diagnostic Procedure

  1. Connect Volvo PTT or Mack Guided Diagnostics (transmission module) and verify MID216-PID177-FMI4 active; read live shaft speeds, clutch position, temp.

  2. Inspect transmission harness for chafe or damage at the case connector and mid-frame crossover.

  3. Check transmission oil level at operating temperature; top up with correct Volvo/Mack spec fluid.

  4. Run clutch calibration / shift actuator learning via PTT or Guided Diagnostics.

  5. Measure sensor resistance at the sensor or TCM connector per service manual spec.

  6. If fault persists after wiring and sensor checks, TCM replacement with programming may be required.

Frequently Asked Questions

What does Volvo/Mack code MID216-PID177-FMI4 mean?

Volvo/Mack code MID216-PID177-FMI4 (Transmission Oil Temperature Voltage Below Normal) is a moderate-severity diagnostic trouble code set on D11/MP7, D13/MP8, and D16/MP10 diesel engines in Volvo VNL/VNR and Mack Anthem/Pinnacle/Granite/Titan trucks. It indicates a fault in the trans oil temp sensor system and should be read with Volvo Premium Tech Tool (PTT) or Mack Guided Diagnostics.

Can I drive a Volvo or Mack truck with code MID216-PID177-FMI4?

Limited short-term operation is usually possible, but the fault will illuminate the Check Engine Light and should be diagnosed promptly to avoid cascading aftertreatment or fueling faults.

How much does it cost to fix Volvo/Mack code MID216-PID177-FMI4?

Typical repair falls in the range $400-$3,500. Sensor/wiring repairs are at the low end; EGR cooler, NOx sensor set, DEF pump, injector, or head work runs at the high end. Volvo PTT or Mack Guided Diagnostics is normally required for calibration and parameter programming.

Explore More

More Volvo/Mack D/MP Series codes → | Diesel home | All diesel codes | Heavy-duty | Guides