Transmission Oil Pressure Critical
The VOLVO-MACK-MID216-PID127-FMI14 (Volvo/Mack D/MP Series) diesel fault code means: Transmission Oil Pressure Critical. This is a critical severity code.
- Keep driving?
- No -- stop driving
- DIY difficulty
- advanced
- Estimated cost
- $400-$3,500
Down with a Volvo fault on the road?
Get connected with a verified mobile diesel mechanic near you. Verified diesel & reefer techs, launching on the freight corridor.
Find a mobile mechanic →A $30 car code reader can't do diesel. The HD7000 reads full-system codes and does parked DPF regen, idle/speed-limit, and service resets from the cab — on everything from a 6.7 Cummins/Power Stroke/Duramax pickup to Class-8 trucks (Detroit, Paccar, CAT, Volvo, Mack, International).
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Full-system 6/9/16-pin diesel scan tool for Cummins, Paccar, CAT, Detroit and more — plug-and-play, no subscription. A cheaper way to read heavy-duty codes a basic OBD2 scanner skips entirely.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Common Symptoms
- Transmission warning lamp illuminated
- Harsh or missed shifts (I-Shift/mDRIVE)
- Neutral lockout or limp-home mode
- Engine will not start (neutral safety fault)
- Check Engine Light with trans fault code
Probable Causes (Ranked by Likelihood)
- Failed transmission hydraulic Likely
- Wiring harness damage at transmission connector Likely
- Low transmission oil level or wrong fluid type Possible
- Clutch wear (for clutch actuator codes) out of adjustment range Possible
- TCM internal fault Less Likely
Step-by-Step Diagnostic Procedure
Connect Volvo PTT or Mack Guided Diagnostics (transmission module) and verify MID216-PID127-FMI14 active; read live shaft speeds, clutch position, temp.
Inspect transmission harness for chafe or damage at the case connector and mid-frame crossover.
Check transmission oil level at operating temperature; top up with correct Volvo/Mack spec fluid.
Run clutch calibration / shift actuator learning via PTT or Guided Diagnostics.
Measure sensor resistance at the sensor or TCM connector per service manual spec.
If fault persists after wiring and sensor checks, TCM replacement with programming may be required.
Frequently Asked Questions
What does Volvo/Mack code MID216-PID127-FMI14 mean?
Volvo/Mack code MID216-PID127-FMI14 (Transmission Oil Pressure Critical) is a critical-severity diagnostic trouble code set on D11/MP7, D13/MP8, and D16/MP10 diesel engines in Volvo VNL/VNR and Mack Anthem/Pinnacle/Granite/Titan trucks. It indicates a fault in the transmission hydraulic system and should be read with Volvo Premium Tech Tool (PTT) or Mack Guided Diagnostics.
Can I drive a Volvo or Mack truck with code MID216-PID127-FMI14?
No — this fault typically triggers derate or forced engine shutdown countdown. Further operation risks engine damage or stranding. Repair before continuing service.
How much does it cost to fix Volvo/Mack code MID216-PID127-FMI14?
Typical repair falls in the range $400-$3,500. Sensor/wiring repairs are at the low end; EGR cooler, NOx sensor set, DEF pump, injector, or head work runs at the high end. Volvo PTT or Mack Guided Diagnostics is normally required for calibration and parameter programming.
Sources
This page is built from documented references. Verify against your own service info before repair work.