ABS Wheel Speed Sensor Erratic (Rear Axle)
The VOLVO-MACK-MID136-PID790-FMI2 (Volvo/Mack D/MP Series) diesel fault code means: ABS Wheel Speed Sensor Erratic (Rear Axle). This is a moderate severity code.
Unverified. We could not confirm this code's definition against freely available manufacturer documentation, so treat the meaning, severity and fix guidance on this page as unconfirmed. Check it against the manufacturer's service information for your exact model and serial range before acting on it. This page is kept out of search engines for that reason, and we are working through this family manual by manual.
- Keep driving?
- Yes, but fix soon
- DIY difficulty
- intermediate
- Estimated cost
- $200-$900
Down with a Volvo fault on the road?
We are building a network of verified mobile diesel and reefer technicians along the freight corridor. It is not live yet — no one can be dispatched to you today. You can see where the pilot is launching and register interest.
View pilot availability →What Are the Symptoms of VOLVO-MACK-MID136-PID790-FMI2?
- ABS warning lamp illuminated
- Possible ATC (traction control) disabled
- ABS disabled during the affected wheel
- Check Engine Light may also set from multiplexing
What Causes VOLVO-MACK-MID136-PID790-FMI2? (Most Likely First)
- Failed ABS wheel speed sensor Likely
- Harness damage at wheel end or frame crossover Likely
- Tone ring contaminated with metal debris Possible
- Incorrect sensor air gap from loose mounting Possible
- ABS ECU fault Less Likely
Can I Still Drive with VOLVO-MACK-MID136-PID790-FMI2?
Yes, but fix soon. VOLVO-MACK-MID136-PID790-FMI2 is rated moderate severity. It is not an immediate stop-driving fault, but it will not clear itself — book the repair rather than ignoring it.
Frequently Asked Questions
What does Volvo/Mack code MID136-PID790-FMI2 mean?
Volvo/Mack code MID136-PID790-FMI2 (ABS Wheel Speed Sensor Erratic (Rear Axle)) is a moderate-severity diagnostic trouble code set on D11/MP7, D13/MP8, and D16/MP10 diesel engines in Volvo VNL/VNR and Mack Anthem/Pinnacle/Granite/Titan trucks. It indicates a fault in the ABS wheel speed sensor system and should be read with Volvo Premium Tech Tool (PTT) or Mack Guided Diagnostics.
Can I drive a Volvo or Mack truck with code MID136-PID790-FMI2?
Limited short-term operation is usually possible, but the fault will illuminate the Check Engine Light and should be diagnosed promptly to avoid cascading aftertreatment or fueling faults.
How much does it cost to fix Volvo/Mack code MID136-PID790-FMI2?
Typical repair falls in the range $200-$900. Sensor/wiring repairs are at the low end; EGR cooler, NOx sensor set, DEF pump, injector, or head work runs at the high end. Volvo PTT or Mack Guided Diagnostics is normally required for calibration and parameter programming.
Mechanics Guide Step-by-step diagnosis
How Do You Diagnose VOLVO-MACK-MID136-PID790-FMI2?
Connect Volvo PTT or Mack Guided Diagnostics (ABS module) and verify MID136-PID790-FMI2 active; read wheel speed live data.
Inspect sensor mounting and air gap; clean tone ring of metallic debris.
Measure sensor resistance at the harness (spec typically 1000-2500 ohms).
Inspect harness routing for chafe at axle flex point and frame crossover.
After repair, road-test above 5 mph to verify fault clears and ABS lamp goes out.
Sources 1
This page is built from documented references. Verify against your own service info before repair work.
- SAE J1939-73Application Layer: Diagnostics (defines the SPN/FMI fault-identifier framework)
Which Vehicles Commonly Get VOLVO-MACK-MID136-PID790-FMI2?
- Volvo VNL 760/860 with D13
- Volvo VNR 640 with D11/D13
- Mack Anthem with MP8
- Mack Pinnacle with MP7/MP8
- Mack Granite with MP7/MP8
- Mack Titan with MP10
Explore More
Was this helpful?
Send this to whoever is fixing the truck — your tech, or the person asking what the fault means.