Español
VOLVO-MACK-MID128-PID3363-FMI16 moderate Volvo/Mack D/MP Series ›

DEF Tank Heater Not Reaching Temperature

My Garage →
Can I Drive?
Yes, But Fix Soon
DIY Difficulty
advanced
Estimated Cost
$500-$2,500

What does VOLVO-MACK-MID128-PID3363-FMI16 mean?

The VOLVO-MACK-MID128-PID3363-FMI16 (Volvo/Mack D/MP Series) diesel fault code means: DEF Tank Heater Not Reaching Temperature. This is a moderate severity code.

Common Symptoms

  • DEF warning lamp illuminated
  • Countdown to engine derate (usually 50 hours)
  • Low DEF or poor DEF quality messages
  • SCR efficiency low (NOx emissions up)
  • 5 mph limp mode if ignored past countdown

Probable Causes (Ranked by Likelihood)

  • Failed DEF pump, doser, heater, or sensor in DEF supply module Likely
  • Harness damage at DEF tank module (common from road debris) Likely
  • DEF line ice blockage (if tank heater failed) Possible
  • Contaminated DEF causing pump or doser fouling Possible
  • ACM (Aftertreatment Control Module) fault Less Likely

Step-by-Step Diagnostic Procedure

  1. Connect Volvo PTT or Mack Guided Diagnostics, verify MID128-PID3363-FMI16 active, and observe DEF pump and doser live data.

  2. Command DEF pump pressure test; pressure should reach 70-130 psi in a few seconds.

  3. Inspect DEF lines for kinks, leaks, or frozen/clogged sections.

  4. Measure heater element resistance at DEF tank module; replace if open.

  5. Check DEF quality with a refractometer; replace contaminated DEF.

  6. After repair, run the SCR initialization and purge sequence via PTT or Guided Diagnostics.

Frequently Asked Questions

What does Volvo/Mack code MID128-PID3363-FMI16 mean?

Volvo/Mack code MID128-PID3363-FMI16 (DEF Tank Heater Not Reaching Temperature) is a moderate-severity diagnostic trouble code set on D11/MP7, D13/MP8, and D16/MP10 diesel engines in Volvo VNL/VNR and Mack Anthem/Pinnacle/Granite/Titan trucks. It indicates a fault in the DEF heater system and should be read with Volvo Premium Tech Tool (PTT) or Mack Guided Diagnostics.

Can I drive a Volvo or Mack truck with code MID128-PID3363-FMI16?

Limited short-term operation is usually possible, but the fault will illuminate the Check Engine Light and should be diagnosed promptly to avoid cascading aftertreatment or fueling faults.

How much does it cost to fix Volvo/Mack code MID128-PID3363-FMI16?

Typical repair falls in the range $500-$2,500. Sensor/wiring repairs are at the low end; EGR cooler, NOx sensor set, DEF pump, injector, or head work runs at the high end. Volvo PTT or Mack Guided Diagnostics is normally required for calibration and parameter programming.

Explore More

More Volvo/Mack D/MP Series codes → | Diesel home | All diesel codes | Heavy-duty | Guides