NOx Sensor Circuit High Input
The PACCAR-P2203 (PACCAR MX) diesel fault code means: NOx Sensor Circuit High Input. This is a moderate severity code.
- Keep driving?
- Yes, but fix soon
- DIY difficulty
- intermediate
- Estimated cost
- $500-$4,200
Down with a PACCAR fault on the road?
Get connected with a verified mobile diesel mechanic near you. Verified diesel & reefer techs, launching on the freight corridor.
Find a mobile mechanic →A $30 car code reader can't do diesel. The HD7000 reads full-system codes and does parked DPF regen, idle/speed-limit, and service resets from the cab — on everything from a 6.7 Cummins/Power Stroke/Duramax pickup to Class-8 trucks (Detroit, Paccar, CAT, Volvo, Mack, International).
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Full-system 6/9/16-pin diesel scan tool for Cummins, Paccar, CAT, Detroit and more — plug-and-play, no subscription. A cheaper way to read heavy-duty codes a basic OBD2 scanner skips entirely.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Common Symptoms
- Check Engine Light with progressive derate
- DEF warning and 5 mph limp eventually
- High DEF consumption
- Failed emissions / CARB inspection
- Possible no-restart inducement active
Probable Causes (Ranked by Likelihood)
- Failed inlet or outlet NOx sensor (most common MX cause) Very Likely
- Crystallized DEF at doser restricting flow Likely
- DEF quality out of spec Possible
- SCR catalyst aged / contaminated (end-of-life) Possible
- Exhaust leak upstream of SCR causing false readings Possible
Step-by-Step Diagnostic Procedure
Clear codes and operate truck through full duty cycle. Re-scan — chronically-failing NOx sensor will re-set quickly.
Graph both NOx sensor values at idle and cruise with DAVIE4. Inlet should read 200-800 ppm; outlet should drop near zero.
Refractometer-test DEF. Concentration below 30% urea indicates contamination.
Inspect SCR inlet/outlet for leaks or damage with smoke machine.
If both sensors and DEF check out, replace aged SCR catalyst and reflash CEM.
Frequently Asked Questions
What does PACCAR MX code P2203 mean?
PACCAR MX code P2203 (NOx Sensor Circuit High Input) is a moderate-severity diagnostic trouble code set by the engine or aftertreatment control module on MX-11 and MX-13 engines in Kenworth and Peterbilt trucks. It indicates a fault in the aftertreatment system that should be diagnosed with DAVIE4 or PACCAR ESA.
Can I drive a Kenworth or Peterbilt with PACCAR P2203?
Possibly — short distances may be OK, but ignoring the fault risks progressive damage, regen failure, or derate. Address promptly.
How much does it cost to fix PACCAR MX P2203?
Typical repair runs $500-$4,200. Sensor or wiring repairs are at the low end; injector, DEF pump, DPF, or EGR cooler jobs are at the high end. Dealer-level DAVIE4 software is often required for programming or calibration after parts replacement.
Sources
This page is built from documented references. Verify against your own service info before repair work.
P2203 on Other Platforms
The same code ID appears across other engines, vehicles, and equipment. Diagnostic flow varies by platform — see the matching breakdown: