VIN Not Programmed
The PACCAR-P1006 (PACCAR MX) diesel fault code means: VIN Not Programmed. This is a moderate severity code.
- Keep driving?
- No -- stop driving
- DIY difficulty
- advanced
- Estimated cost
- $1,800-$4,500
Down with a PACCAR fault on the road?
Get connected with a verified mobile diesel mechanic near you. Verified diesel & reefer techs, launching on the freight corridor.
Find a mobile mechanic →A $30 car code reader can't do diesel. The HD7000 reads full-system codes and does parked DPF regen, idle/speed-limit, and service resets from the cab — on everything from a 6.7 Cummins/Power Stroke/Duramax pickup to Class-8 trucks (Detroit, Paccar, CAT, Volvo, Mack, International).
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Full-system 6/9/16-pin diesel scan tool for Cummins, Paccar, CAT, Detroit and more — plug-and-play, no subscription. A cheaper way to read heavy-duty codes a basic OBD2 scanner skips entirely.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Common Symptoms
- Check Engine Light illuminated
- Possible no-start or stalling
- Scan tool communication loss
- Engine derate or limp mode
Probable Causes (Ranked by Likelihood)
- ECM internal hardware fault Likely
- Software corruption requiring reflash Likely
- Power or ground circuit issue Possible
- Low battery voltage during key-on Possible
Step-by-Step Diagnostic Procedure
Connect DAVIE4 or PACCAR ESA and confirm P1006 is active with freeze frame data.
Measure ECM supply voltage at pin — must be battery voltage key-on and stable during cranking.
Inspect ECM grounds at frame rail for clean, corrosion-free connections.
Check for PACCAR calibration updates and reflash if available.
If fault persists after reflash and wiring checks, ECM replacement with DAVIE4 programming is required.
Frequently Asked Questions
What does PACCAR MX code P1006 mean?
PACCAR MX code P1006 (VIN Not Programmed) is a moderate-severity diagnostic trouble code set by the engine or aftertreatment control module on MX-11 and MX-13 engines in Kenworth and Peterbilt trucks. It indicates a fault in the engine control system that should be diagnosed with DAVIE4 or PACCAR ESA.
Can I drive a Kenworth or Peterbilt with PACCAR P1006?
No — this fault typically triggers engine derate or forced shutdown countdown. Continuing to operate risks further damage or a stranded truck.
How much does it cost to fix PACCAR MX P1006?
Typical repair runs $1,800-$4,500. Sensor or wiring repairs are at the low end; injector, DEF pump, DPF, or EGR cooler jobs are at the high end. Dealer-level DAVIE4 software is often required for programming or calibration after parts replacement.
Sources
This page is built from documented references. Verify against your own service info before repair work.
P1006 on Other Platforms
The same code ID appears across other engines, vehicles, and equipment. Diagnostic flow varies by platform — see the matching breakdown: