Barometric Pressure Sensor - Data Erratic, Intermittent, or Incorrect
The JD-SPN108-FMI2 (John Deere PowerTech) diesel fault code means: Barometric Pressure Sensor - Data Erratic, Intermittent, or Incorrect. This is a serious severity code.
- Keep driving?
- Yes, but fix soon
- DIY difficulty
- intermediate
- Estimated cost
- $90-$320 sensor + install
A $30 car code reader can't do diesel. The HD7000 reads full-system codes and does parked DPF regen, idle/speed-limit, and service resets from the cab — on everything from a 6.7 Cummins/Power Stroke/Duramax pickup to Class-8 trucks (Detroit, Paccar, CAT, Volvo, Mack, International).
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Full-system 6/9/16-pin diesel scan tool for Cummins, Paccar, CAT, Detroit and more — plug-and-play, no subscription. A cheaper way to read heavy-duty codes a basic OBD2 scanner skips entirely.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Common Symptoms
- Fault lamp on operator display
- Possible derate once confirmed active
- Inaccurate dashboard readout for the affected parameter
Probable Causes (Ranked by Likelihood)
- Failed sensor element or contaminated sensor tip Likely
- Broken, chafed, or corroded sensor harness connector Very Likely
- Open / short to ground between sensor and ECU Possible
- ECU signal input fault (rare) Less Likely
Step-by-Step Diagnostic Procedure
Use John Deere Service ADVISOR (CF3/EDL v3) and capture live sensor value vs. expected range.
Back-probe the sensor harness -- verify 5V reference and signal return at the ECU connector.
Swap the sensor with a known-good matching part number and clear the code.
Check CAN data trace for sensor broadcast on J1939 before condemning the ECU.
Frequently Asked Questions
What is John Deere fault code SPN 108 FMI 2?
On John Deere PowerTech engines, SPN 108 FMI 2 means: Barometric Pressure Sensor - Data Erratic, Intermittent, or Incorrect. Serious code -- address promptly to avoid inducement / further damage.
Can I keep using my John Deere tractor with SPN 108 FMI 2?
Serious fault -- you can move the machine to a shop but don't run it under load. Diagnose with John Deere Service ADVISOR via an EDL v3 / CF3 interface.
How much does it cost to fix John Deere SPN 108 FMI 2?
Repair cost range: $90-$320 sensor + install. Dealer labor on large tractors runs $180-$240/hr in 2026.
Sources
This page is built from documented references. Verify against your own service info before repair work.