Lost Communication with TCM (Aisin / GM trans)
The ISUZU-U0101 (Isuzu) diesel fault code means: Lost Communication with TCM (Aisin / GM trans). This is a serious severity code.
- Keep driving?
- Yes, but fix soon
- DIY difficulty
- intermediate
- Estimated cost
- $250-$2,800
Down with a Isuzu fault on the road?
Get connected with a verified mobile diesel mechanic near you. Verified diesel & reefer techs, launching on the freight corridor.
Find a mobile mechanic →A $30 car code reader can't do diesel. The HD7000 reads full-system codes and does parked DPF regen, idle/speed-limit, and service resets from the cab — on everything from a 6.7 Cummins/Power Stroke/Duramax pickup to Class-8 trucks (Detroit, Paccar, CAT, Volvo, Mack, International).
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Full-system 6/9/16-pin diesel scan tool for Cummins, Paccar, CAT, Detroit and more — plug-and-play, no subscription. A cheaper way to read heavy-duty codes a basic OBD2 scanner skips entirely.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Common Symptoms
- Check Engine Light with multiple codes set together
- Crank-no-start (CKP/CMP faults)
- Speedometer / gauge dropout
- Transmission limp mode
- Intermittent scan tool communication loss
Probable Causes (Ranked by Likelihood)
- Damaged sensor or wiring in affected circuit Likely
- CAN bus harness chafe on frame rail or engine mount Possible
- Weak batteries / poor grounds on dual-battery 4HK1 setup Possible
- Failed ECM / TCM (rare) Less Likely
- Water intrusion at body/cab harness disconnect Possible
Step-by-Step Diagnostic Procedure
Inspect main engine-to-body ground strap — corroded ground on NPR/NQR is a top cause of U-codes.
Test battery voltage at rest (>12.4V) and during cranking (>9.6V); replace weak batteries before chasing U-codes.
Check CAN H / CAN L resistance at the diagnostic connector — should read ~60 ohms with key off.
For CKP / CMP: ohm sensor, inspect reluctor wheel for damage, verify proper air gap with feeler gauge.
If wiring and voltages check out, perform ECM/TCM self-test using IDSS.
Frequently Asked Questions
What does Isuzu code U0101 mean?
Isuzu diagnostic trouble code U0101 (Lost Communication with TCM (Aisin / GM trans)) is a serious-severity fault on Isuzu medium-duty diesel engines. It indicates a problem in the communication that should be verified with a scan tool (Isuzu IDSS / Tech2 for Isuzu) before replacing any parts.
Can I drive my Isuzu truck with U0101?
Short runs may be possible but do not ignore — Isuzu medium-duty aftertreatment faults cascade quickly into 5-mph derate or no-restart. Schedule diagnosis immediately.
How much does it cost to fix Isuzu U0101?
Typical repair cost runs $250-$2,800. Sensor, wiring, and DEF-related repairs fall at the low end; DPF service, turbo, injector, and EGR cooler work fall at the high end and may require dealer-level programming.
Sources
This page is built from documented references. Verify against your own service info before repair work.
U0101 on Other Platforms
The same code ID appears across other engines, vehicles, and equipment. Diagnostic flow varies by platform — see the matching breakdown: