Aftertreatment Fuel Injector - Current Below Normal
The CUMMINS-3762 (Cummins) diesel fault code means: Aftertreatment Fuel Injector - Current Below Normal. This is a moderate severity code.
- Keep driving?
- Yes, but fix soon
- DIY difficulty
- advanced
- Estimated cost
- $400-$1,200
Down with a Cummins fault on the road?
Get connected with a verified mobile diesel mechanic near you. Verified diesel & reefer techs, launching on the freight corridor.
Find a mobile mechanic →A $30 car code reader can't do diesel. The HD7000 reads full-system codes and does parked DPF regen, idle/speed-limit, and service resets from the cab — on everything from a 6.7 Cummins/Power Stroke/Duramax pickup to Class-8 trucks (Detroit, Paccar, CAT, Volvo, Mack, International).
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Full-system 6/9/16-pin diesel scan tool for Cummins, Paccar, CAT, Detroit and more — plug-and-play, no subscription. A cheaper way to read heavy-duty codes a basic OBD2 scanner skips entirely.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Common Symptoms
- DPF lamp illuminated on dash
- Active regeneration messages on dash
- Increased backpressure and reduced power
- Higher than normal fuel consumption
- Black smoke out of stack when accelerating
Probable Causes (Ranked by Likelihood)
- DPF severely loaded with soot requiring forced regen Very Likely
- Excessive ash accumulation (cleaning required) Likely
- Failed differential pressure sensor or hoses plugged Likely
- Short-trip duty cycle prevented passive regen Possible
- Faulty DOC (upstream oxidation catalyst) Possible
- Aftertreatment fuel injector stuck or clogged Less Likely
Step-by-Step Diagnostic Procedure
Connect INSITE and read soot load estimate, differential pressure, and last regen status for fault 3762.
Park truck safely in non-combustible area with parking brake and initiate a parked/forced regeneration via INSITE.
If forced regen fails or DPF is above 100% soot load, remove DPF for professional cleaning (ash + soot bake).
Inspect differential pressure sensor hoses at DPF for soot clogging or kinks -- replace if obstructed.
Verify DOC inlet temperature rises above 570 degrees F during regen command (DOC functional check).
Inspect aftertreatment fuel doser or dosing injector for clogging; clean or replace as needed.
Frequently Asked Questions
What is Cummins fault code 3762?
Cummins fault code 3762 indicates: Aftertreatment Fuel Injector - Current Below Normal. It is a moderate-severity fault in the aftertreatment or emissions system.
Can I drive with Cummins fault code 3762?
Yes, short-term driving is typically safe with fault 3762, but the fault will illuminate the Check Engine Light and must be diagnosed soon. Monitor for power loss, unusual noises, or gauge changes and pull over if conditions worsen.
How much does it cost to fix Cummins fault 3762?
Repair cost is approximately $400-$1,200 including parts, labor, and any dealer programming required. DIY repairs (sensor replacement) fall at the low end; pump, aftertreatment, or ECM work falls at the high end and usually requires INSITE diagnostic software.
Sources
This page is built from documented references. Verify against your own service info before repair work.