Engine Oil Temperature High - Warning
The CUMMINS-258 (Cummins) diesel fault code means: Engine Oil Temperature High - Warning. This is a moderate severity code.
- Keep driving?
- Yes, but fix soon
- DIY difficulty
- intermediate
- Estimated cost
- $200-$1,500
Down with a Cummins fault on the road?
Get connected with a verified mobile diesel mechanic near you. Verified diesel & reefer techs, launching on the freight corridor.
Find a mobile mechanic →A $30 car code reader can't do diesel. The HD7000 reads full-system codes and does parked DPF regen, idle/speed-limit, and service resets from the cab — on everything from a 6.7 Cummins/Power Stroke/Duramax pickup to Class-8 trucks (Detroit, Paccar, CAT, Volvo, Mack, International).
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Full-system 6/9/16-pin diesel scan tool for Cummins, Paccar, CAT, Detroit and more — plug-and-play, no subscription. A cheaper way to read heavy-duty codes a basic OBD2 scanner skips entirely.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Common Symptoms
- Engine temperature or pressure abnormal
- Possible engine derate or shutdown
- Dash warning lamp illuminated
- Gauges reading outside normal range
- Audible engine change (knock, ticking, or hiss)
- Overheat warning alarm sounding
Probable Causes (Ranked by Likelihood)
- Actual mechanical issue (low oil, coolant, temp) Very Likely
- Failed sensor falsely reporting Likely
- Cooling system issue (fan, radiator, pump) Possible
- Head gasket or combustion gas leak Possible
- Obstructed airflow at charge air cooler Less Likely
Step-by-Step Diagnostic Procedure
Verify the physical condition indicated by fault 258 -- for temperature codes, confirm with an IR thermometer; for pressure codes, use a mechanical gauge.
Compare mechanical reading to sensor reading on INSITE -- if they disagree, sensor or wiring is faulty.
Inspect the mechanical system (cooling, oil, fuel supply) for the underlying issue reported by the sensor.
Check engine fan operation, coolant level, and radiator condition for temp-related codes.
If mechanical reading confirms the fault, repair the underlying system before clearing codes -- clearing without fix will cause fault return and potential engine damage.
Frequently Asked Questions
What is Cummins fault code 258?
Cummins fault code 258 indicates: Engine Oil Temperature High - Warning. It is a moderate-severity fault affecting engine mechanical condition.
Can I drive with Cummins fault code 258?
Short-term, yes, but the engine will enter derate (typically starting at 55 mph and progressing to 5 mph for emissions faults). Drive directly to a repair facility. Do not defer this fault more than a few operating hours.
How much does it cost to fix Cummins fault 258?
Repair cost is approximately $200-$1,500 including parts, labor, and any dealer programming required. DIY repairs (sensor replacement) fall at the low end; pump, aftertreatment, or ECM work falls at the high end and usually requires INSITE diagnostic software.
Sources
This page is built from documented references. Verify against your own service info before repair work.