Sensor Supply Voltage 3 Circuit - Voltage Below Normal
What does CUMMINS-238 mean?
The CUMMINS-238 (Cummins) diesel fault code means: Sensor Supply Voltage 3 Circuit - Voltage Below Normal. This is a moderate severity code.
Common Symptoms
- Multiple warning lights illuminated
- Intermittent sensor faults
- Erratic dash gauge behavior
- Possible engine stall
- Battery or charging system warnings
Probable Causes (Ranked by Likelihood)
- Sensor supply (5V reference) circuit fault Very Likely
- Harness chafing causing short or open Likely
- Loose or corroded ground connection Likely
- Multiple sensors drawing on same supply overloaded Possible
- ECM internal supply driver failure Less Likely
Step-by-Step Diagnostic Procedure
Connect INSITE and read all active codes related to fault 238 -- multiple sensor faults on one supply indicate a supply fault.
Measure 5V reference supply voltage at ECM pin and at the sensor connector; must be 4.9-5.1V stable.
Unplug sensors one at a time while watching live data to find a sensor pulling the supply low.
Inspect harness for chafing where it crosses the engine or frame; look for green or bright corrosion at connectors.
Verify battery voltage and alternator output are within spec (13.8-14.4V engine running).
Frequently Asked Questions
What is Cummins fault code 238?
Cummins fault code 238 indicates: Sensor Supply Voltage 3 Circuit - Voltage Below Normal. It is a moderate-severity fault affecting engine electrical supply or communications.
Can I drive with Cummins fault code 238?
Yes, short-term driving is typically safe with fault 238, but the fault will illuminate the Check Engine Light and must be diagnosed soon. Monitor for power loss, unusual noises, or gauge changes and pull over if conditions worsen.
How much does it cost to fix Cummins fault 238?
Repair cost is approximately $200-$600 including parts, labor, and any dealer programming required. DIY repairs (sensor replacement) fall at the low end; pump, aftertreatment, or ECM work falls at the high end and usually requires INSITE diagnostic software.