Engine Oil Pressure Extremely Low - Shutdown
What does CUMMINS-219 mean?
The CUMMINS-219 (Cummins) diesel fault code means: Engine Oil Pressure Extremely Low - Shutdown. This is a critical severity code.
Common Symptoms
- Engine protect mode or forced shutdown
- Engine temperature or pressure abnormal
- Possible engine derate or shutdown
- Dash warning lamp illuminated
- Gauges reading outside normal range
- Audible engine change (knock, ticking, or hiss)
Probable Causes (Ranked by Likelihood)
- Actual mechanical issue (low oil, coolant, temp) Very Likely
- Failed sensor falsely reporting Likely
- Cooling system issue (fan, radiator, pump) Possible
- Head gasket or combustion gas leak Possible
- Obstructed airflow at charge air cooler Less Likely
Step-by-Step Diagnostic Procedure
Verify the physical condition indicated by fault 219 -- for temperature codes, confirm with an IR thermometer; for pressure codes, use a mechanical gauge.
Compare mechanical reading to sensor reading on INSITE -- if they disagree, sensor or wiring is faulty.
Inspect the mechanical system (cooling, oil, fuel supply) for the underlying issue reported by the sensor.
Check engine fan operation, coolant level, and radiator condition for temp-related codes.
If mechanical reading confirms the fault, repair the underlying system before clearing codes -- clearing without fix will cause fault return and potential engine damage.
Frequently Asked Questions
What is Cummins fault code 219?
Cummins fault code 219 indicates: Engine Oil Pressure Extremely Low - Shutdown. It is a critical-severity fault affecting engine mechanical condition.
Can I drive with Cummins fault code 219?
No. Fault code 219 triggers protective engine shutdown or severe derate. Continued operation risks engine damage or stranding. Tow to a Cummins dealer or qualified diesel shop.
How much does it cost to fix Cummins fault 219?
Repair cost is approximately $500-$5,000 including parts, labor, and any dealer programming required. DIY repairs (sensor replacement) fall at the low end; pump, aftertreatment, or ECM work falls at the high end and usually requires INSITE diagnostic software.