Aftertreatment 1 SCR Outlet Temperature - Voltage Above Normal
The CUMMINS-1683 (Cummins) diesel fault code means: Aftertreatment 1 SCR Outlet Temperature - Voltage Above Normal. This is a moderate severity code.
- Keep driving?
- Yes, but fix soon
- DIY difficulty
- intermediate
- Estimated cost
- $300-$800
Down with a Cummins fault on the road?
Get connected with a verified mobile diesel mechanic near you. Verified diesel & reefer techs, launching on the freight corridor.
Find a mobile mechanic →A $30 car code reader can't do diesel. The HD7000 reads full-system codes and does parked DPF regen, idle/speed-limit, and service resets from the cab — on everything from a 6.7 Cummins/Power Stroke/Duramax pickup to Class-8 trucks (Detroit, Paccar, CAT, Volvo, Mack, International).
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Full-system 6/9/16-pin diesel scan tool for Cummins, Paccar, CAT, Detroit and more — plug-and-play, no subscription. A cheaper way to read heavy-duty codes a basic OBD2 scanner skips entirely.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Common Symptoms
- Amber check engine warning light
- DEF or DPF lamp illuminated
- Engine derate at 55 mph then 5 mph
- Failed active regeneration attempts
- Increased DEF or fuel consumption
Probable Causes (Ranked by Likelihood)
- Failed temperature sensor element Very Likely
- Wiring damage from exhaust heat Likely
- Connector corrosion at sensor body Likely
- Aftertreatment Control Module (ACM) fault Possible
- Exhaust leak affecting sensor reading Possible
Step-by-Step Diagnostic Procedure
Connect INSITE and read live data for the sensor tied to SPN 4766 -- compare against commanded value at idle and load.
Disconnect sensor and measure resistance across signal pins -- compare to Cummins service manual spec.
Inspect harness along exhaust routing for heat damage, rubbing, or melted insulation.
Check for exhaust leaks at clamps and gaskets upstream of the sensor location.
Repeat fault check after sensor replacement; if fault returns, suspect ACM (Aftertreatment Control Module) fault.
Frequently Asked Questions
What is Cummins fault code 1683?
Cummins fault code 1683 indicates: Aftertreatment 1 SCR Outlet Temperature - Voltage Above Normal. It is a moderate-severity fault in the aftertreatment or emissions system.
Can I drive with Cummins fault code 1683?
Yes, short-term driving is typically safe with fault 1683, but the fault will illuminate the Check Engine Light and must be diagnosed soon. Monitor for power loss, unusual noises, or gauge changes and pull over if conditions worsen.
How much does it cost to fix Cummins fault 1683?
Repair cost is approximately $300-$800 including parts, labor, and any dealer programming required. DIY repairs (sensor replacement) fall at the low end; pump, aftertreatment, or ECM work falls at the high end and usually requires INSITE diagnostic software.
Sources
This page is built from documented references. Verify against your own service info before repair work.