Aftertreatment 1 Diesel Particulate Filter Missing
The CUMMINS-1664 (Cummins) diesel fault code means: Aftertreatment 1 Diesel Particulate Filter Missing. This is a critical severity code.
- Keep driving?
- No -- stop driving
- DIY difficulty
- advanced
- Estimated cost
- $2,500-$7,500
Down with a Cummins fault on the road?
Get connected with a verified mobile diesel mechanic near you. Verified diesel & reefer techs, launching on the freight corridor.
Find a mobile mechanic →A $30 car code reader can't do diesel. The HD7000 reads full-system codes and does parked DPF regen, idle/speed-limit, and service resets from the cab — on everything from a 6.7 Cummins/Power Stroke/Duramax pickup to Class-8 trucks (Detroit, Paccar, CAT, Volvo, Mack, International).
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Full-system 6/9/16-pin diesel scan tool for Cummins, Paccar, CAT, Detroit and more — plug-and-play, no subscription. A cheaper way to read heavy-duty codes a basic OBD2 scanner skips entirely.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Common Symptoms
- Engine protect mode or forced shutdown
- DPF lamp illuminated on dash
- Active regeneration messages on dash
- Increased backpressure and reduced power
- Higher than normal fuel consumption
- Black smoke out of stack when accelerating
Probable Causes (Ranked by Likelihood)
- DPF severely loaded with soot requiring forced regen Very Likely
- Excessive ash accumulation (cleaning required) Likely
- Failed differential pressure sensor or hoses plugged Likely
- Short-trip duty cycle prevented passive regen Possible
- Faulty DOC (upstream oxidation catalyst) Possible
- Aftertreatment fuel injector stuck or clogged Less Likely
Step-by-Step Diagnostic Procedure
Connect INSITE and read soot load estimate, differential pressure, and last regen status for fault 1664.
Park truck safely in non-combustible area with parking brake and initiate a parked/forced regeneration via INSITE.
If forced regen fails or DPF is above 100% soot load, remove DPF for professional cleaning (ash + soot bake).
Inspect differential pressure sensor hoses at DPF for soot clogging or kinks -- replace if obstructed.
Verify DOC inlet temperature rises above 570 degrees F during regen command (DOC functional check).
Inspect aftertreatment fuel doser or dosing injector for clogging; clean or replace as needed.
Frequently Asked Questions
What is Cummins fault code 1664?
Cummins fault code 1664 indicates: Aftertreatment 1 Diesel Particulate Filter Missing. It is a critical-severity fault in the aftertreatment or emissions system.
Can I drive with Cummins fault code 1664?
No. Fault code 1664 triggers protective engine shutdown or severe derate. Continued operation risks engine damage or stranding. Tow to a Cummins dealer or qualified diesel shop.
How much does it cost to fix Cummins fault 1664?
Repair cost is approximately $2,500-$7,500 including parts, labor, and any dealer programming required. DIY repairs (sensor replacement) fall at the low end; pump, aftertreatment, or ECM work falls at the high end and usually requires INSITE diagnostic software.
Sources
This page is built from documented references. Verify against your own service info before repair work.