Intake Manifold Temp Above Normal
The CAT-SPN105-FMI0 (Caterpillar) diesel fault code means: Intake Manifold Temp Above Normal. This is a moderate severity code.
- Keep driving?
- Yes, but fix soon
- DIY difficulty
- intermediate
- Estimated cost
- $200-$1500
Down with a CAT fault on the road?
Get connected with a verified mobile diesel mechanic near you. Verified diesel & reefer techs, launching on the freight corridor.
Find a mobile mechanic →A $30 car code reader can't do diesel. The HD7000 reads full-system codes and does parked DPF regen, idle/speed-limit, and service resets from the cab — on everything from a 6.7 Cummins/Power Stroke/Duramax pickup to Class-8 trucks (Detroit, Paccar, CAT, Volvo, Mack, International).
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Full-system 6/9/16-pin diesel scan tool for Cummins, Paccar, CAT, Detroit and more — plug-and-play, no subscription. A cheaper way to read heavy-duty codes a basic OBD2 scanner skips entirely.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Common Symptoms
- Check Engine Light or warning lamp
- Engine protect / derate / shutdown possible
- System performance affected
Probable Causes (Ranked by Likelihood)
- Sensor / actuator internal failure Likely
- Wiring or connector issue in the affected circuit Likely
- Related system mechanical issue Possible
- ECM calibration or software issue Less Likely
Step-by-Step Diagnostic Procedure
Connect CAT ET and confirm the SPN/FMI is active; record live data for the affected parameter.
Inspect wiring and connectors for the affected circuit; back-probe and check with a DMM.
Perform component test on the sensor / actuator per CAT service manual.
Repair wiring, replace component, or reflash ECM as CAT ET diagnostics direct.
Frequently Asked Questions
What does CAT SPN105-FMI0 mean?
CAT SPN105-FMI0 (Intake Manifold Temp Above Normal) is a moderate-severity fault reported over the J1939 data link. IMT too hot — charge air cooler / intercooler issue. CAT ECMs report many of the same faults both as CID/FMI (proprietary) and SPN/FMI (J1939) — either form points to the same physical issue.
Can I drive with CAT SPN105-FMI0?
Short distances may be acceptable, but plan the repair promptly. Ignoring the fault risks progressive damage or derate.
How much does CAT SPN105-FMI0 cost to fix?
Typical repair is $200-$1500. Simple sensor/wiring repairs fall at the low end; component, actuator, or aftertreatment work falls at the high end and usually requires CAT ET for programming.
Sources
This page is built from documented references. Verify against your own service info before repair work.