Engine Speed / Crankshaft Sensor - Voltage Above Normal (Open/Short to High)
The CAT-CID190-FMI3 (Caterpillar) diesel fault code means: Engine Speed / Crankshaft Sensor - Voltage Above Normal (Open/Short to High). This is a serious severity code.
- Keep driving?
- Yes, but fix soon
- DIY difficulty
- intermediate
- Estimated cost
- $150-$500
Down with a CAT fault on the road?
Get connected with a verified mobile diesel mechanic near you. Verified diesel & reefer techs, launching on the freight corridor.
Find a mobile mechanic →A $30 car code reader can't do diesel. The HD7000 reads full-system codes and does parked DPF regen, idle/speed-limit, and service resets from the cab — on everything from a 6.7 Cummins/Power Stroke/Duramax pickup to Class-8 trucks (Detroit, Paccar, CAT, Volvo, Mack, International).
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Full-system 6/9/16-pin diesel scan tool for Cummins, Paccar, CAT, Detroit and more — plug-and-play, no subscription. A cheaper way to read heavy-duty codes a basic OBD2 scanner skips entirely.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Common Symptoms
- Check Engine Light
- Sensor reads pegged high or low on CAT ET
- Associated systems may derate or default
Probable Causes (Ranked by Likelihood)
- Open circuit in signal wire or unplugged connector Very Likely
- Sensor internally failed open Likely
- Corroded or backed-out connector pin Likely
- Signal wire shorted to sensor supply Possible
Step-by-Step Diagnostic Procedure
Connect CAT ET and confirm the CID and FMI is active. Note the reported sensor reading.
Disconnect the sensor connector and verify reference voltage at the supply pin key-on.
Jumper signal to return at the connector; if the value swings to the opposite extreme on ET, the sensor is bad.
If no swing, ohm signal wire from connector back to ECM pin; repair open or replace sensor as indicated.
Frequently Asked Questions
What does CAT code CID190-FMI3 mean?
CAT code CID190-FMI3 (Engine Speed / Crankshaft Sensor - Voltage Above Normal (Open/Short to High)) is a serious-severity fault on Caterpillar on-highway diesel engines. CID 190 is the Engine Speed / Crankshaft Sensor, measuring primary crank speed signal. FMI 3 (Voltage Above Normal (Open/Short to High)) indicates the specific fault mode. Use CAT ET to confirm before replacing parts. Diagnose with CAT ET (Electronic Technician) software.
Can I drive my truck with CAT code CID190-FMI3?
Short distances may be acceptable, but running long with this fault risks progressive damage or forced derate. Address promptly.
How much does it cost to fix CAT CID190-FMI3?
Typical repair is $150-$500. Sensor / wiring fixes fall at the low end; injector, HEUI pump, turbo, or aftertreatment work falls at the high end. CAT dealer labor often requires CAT ET for calibration and parameter programming.
Sources
This page is built from documented references. Verify against your own service info before repair work.