Invalid Data Received From Instrument Panel Module B
The U0422 code means the vehicle's onboard diagnostic system has detected: Invalid Data Received From Instrument Panel Module B. This is a moderate severity code.
- Keep driving?
- Yes, but fix soon
- DIY difficulty
- moderate
- Estimated cost
- $200 - $800 (parts and labor)
Network codes mean modules are not communicating. You need a scanner that reads all systems to find the problem.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Common Symptoms
- Secondary display showing errors
- Driver information display blank
- Trip computer data incorrect
- Message center not updating
- Climate display on dash incorrect
Probable Causes (Ranked by Likelihood)
- Failed secondary display module Very High
- CAN bus data error High
- Display connector fault Moderate
- Software corruption in display module Low
Step-by-Step Diagnostic Procedure
-
Scan display module for codes
-
Check display connector
-
Test CAN bus at display module
-
Try software reset of display
Common Fixes by Vehicle
What techs usually find when diagnosing U0422 on specific vehicles — tap your vehicle for the fix and the exact part:
2007-2014 Ford F-150/Expedition moderate DIY
U0422 (invalid data from BCM) on Ford trucks typically means the BCM is reporting impossible values -- often a battery voltage reading out of range or a sensor input that has gone erratic. The most common cause is low battery voltage or a failing battery. Load-test the battery first. If the battery is fine, check BCM power and ground. FORScan can read live BCM data to pinpoint which signal is invalid.
Labor: 1-2 hours2003-2014 Chevrolet Silverado/GMC Sierra moderate DIY
GM truck U0422 often indicates the BCM is sending odd data because of a low battery or bad ground. Clean the BCM grounds under the driver-side dash. Verify battery voltage at the BCM (pin 2) is within 0.2V of battery. If all grounds and power are clean and the code persists, the BCM may need replacement and programming via a GM scan tool or Tech2Win.
Labor: 1-2 hours2005-2015 Dodge Ram 1500 hard DIY
Ram U0422 is often tied to TIPM issues since the TIPM contains BCM functions on many years. A water-damaged or failing TIPM reports invalid data and sets U0422. Open the TIPM, inspect for corrosion, and replace if damaged. Aftermarket rebuilt TIPMs run $300-500. Programming is required after TIPM replacement.
Labor: 2-4 hoursFrequently Asked Questions
Can I drive with U0422?
Yes. The secondary display may show incorrect info but driving systems work.
What causes U0422?
Usually a failed secondary display module or corrupted software.
How much does U0422 cost to fix?
Typically $200 to $800.
Sources
This page is built from documented references. Verify against your own service info before repair work.
See All Codes & Fixes for Your Vehicle
Explore More
Was this helpful?
Share carcodefinder.com with a friend who needs to decode their check engine light.