Lost Communication With Gateway "D"
The U0149 code means the vehicle's onboard diagnostic system has detected: Lost Communication With Gateway "D". This is a moderate severity code.
- Keep driving?
- Yes, but fix soon
- DIY difficulty
- moderate
- Estimated cost
- $50 - $600 (fuses, grounds, or wiring most often; module replacement only after the circuit tests good)
Network codes mean modules are not communicating. You need a scanner that reads all systems to find the problem.
Affiliate links — we earn a commission at no extra cost to you.
What Are the Symptoms of U0149?
- Check Engine or related warning light on
- The Gateway "D"'s functions may be degraded or offline
- Often stored alongside other U-codes when a whole bus segment drops
- Symptoms can be intermittent - connector and wiring faults come and go with heat and vibration
What Causes U0149? (Most Likely First)
- The Gateway "D" has lost power or ground (check its fuses first) High
- CAN bus wiring damage - chafed harness, corroded connector, water intrusion High
- Failed Gateway "D" no longer transmitting Moderate
- Another faulted module loading down the bus Low
Can I Still Drive with U0149?
Yes, but fix soon. U0149 is rated moderate severity. It is not an immediate stop-driving fault, but it will not clear itself — book the repair rather than ignoring the light.
Frequently Asked Questions
What does U0149 mean?
U0149 means other modules stopped receiving messages from the Gateway "D" on the vehicle network. It is a communication fault - the module may be fine but unreachable.
Can I keep driving with U0149?
Usually yes for a short period. The affected function may be degraded, and intermittent wiring faults tend to worsen - diagnose soon.
Should I replace the module for U0149?
Not first. Most communication codes are power, ground, fuse, or wiring problems. Replace the module only after those test good - modules are expensive and often require programming.
Mechanics Guide Step-by-step diagnosis
How Do You Diagnose U0149?
-
Scan ALL modules - the pattern of which modules report lost communication localizes the break.
-
Check the fuses and grounds feeding the Gateway "D" before suspecting the module itself.
-
If many modules are unreachable, test the CAN bus: about 60 ohms across CAN High/Low (two 120-ohm terminators) with the battery disconnected.
-
Wiggle-test connectors along the affected harness while watching for the module to drop on and off.
-
Only after power, ground, and bus test good should the Gateway "D" be suspected.
Sources 2
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)
- Cross-checked against the SAE J2012:2002 DTC table (2026-08-27)archived scan of the SAE standard — readable copy, not SAE’s current edition
Which Vehicles Commonly Get U0149?
- All OBD-II vehicles - network (U) codes are standardized across makes
Explore More
Was this helpful?
Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.