Transmission Control Module Reprogramming Needed
The P2944 code means the vehicle's onboard diagnostic system has detected: Transmission Control Module Reprogramming Needed. This is a moderate severity code.
- Keep driving?
- Short distances only
- DIY difficulty
- hard
- Estimated cost
- $400 - $1,500 (parts and labor)
Read and clear transmission codes. Many trans codes are caused by low or burnt fluid -- check level and color before assuming the worst.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Basic scanners only read engine codes. This reads transmission, ABS, and airbag too.
Check Price on AmazonAffiliate link -- we earn a commission at no extra cost to you.
Common Symptoms
- Erratic shifting behavior
- Multiple transmission codes stored
- Check Engine Light on
- Intermittent transmission malfunctions
Probable Causes (Ranked by Likelihood)
- TCM internal processor failure Very High
- TCM software corruption High
- Power supply voltage issues Moderate
- Ground circuit problems Low
Step-by-Step Diagnostic Procedure
-
Scan for all DTCs and freeze frames
-
Check TCM power and ground circuits
-
Verify TCM software version
-
Test TCM communication on CAN bus
Frequently Asked Questions
Is this a serious problem?
This is a moderate concern that should be addressed soon to prevent further damage.
Can a fluid change help?
A fluid change is unlikely to resolve this specific issue, though it should be part of any transmission service.
How much does repair cost?
Typical repair costs range from $400 - $1,500 depending on the specific cause and vehicle.
Sources
This page is built from documented references. Verify against your own service info before repair work.
Explore More
Was this helpful?
Share carcodefinder.com with a friend who needs to decode their check engine light.