Traction Control Input Signal Low
The P0858 code means the vehicle's onboard diagnostic system has detected: Traction Control Input Signal Low. This is a moderate severity code.
- Keep driving?
- Short distances only
- DIY difficulty
- hard
- Estimated cost
- $100 - $800 (parts and labor)
Read and clear transmission codes. Many trans codes are caused by low or burnt fluid -- check level and color before assuming the worst.
Basic scanners only read engine codes. This reads transmission, ABS, and airbag too.
Affiliate links — we earn a commission at no extra cost to you.
What Are the Symptoms of P0858?
- Check Engine Light illuminated
- Traction control system disabled
- TCM does not receive traction control commands
- Stability control warning light on
What Causes P0858? (Most Likely First)
- Short to ground in traction control signal wire to TCM Very High
- Faulty ABS/traction control module output High
- Corroded wiring connector in signal path Moderate
- TCM input circuit pulled low Low
Can I Still Drive with P0858?
Short distances only. P0858 is rated moderate severity. Keep trips short and get it diagnosed soon rather than waiting for symptoms to worsen.
Frequently Asked Questions
What happens if the traction control signal stays low?
The TCM will not receive traction control commands and will not reduce torque during wheel slip events. The vehicle can still be driven but with reduced stability assistance.
Is P0858 related to the ABS system?
Yes, traction control is a function of the ABS system. The ABS module sends traction control data to the TCM, so ABS faults can trigger transmission-related codes.
Can I just disconnect the traction control?
Disabling traction control is not recommended as it reduces vehicle safety. The underlying electrical fault should be repaired.
Mechanics Guide Step-by-step diagnosis
How Do You Diagnose P0858?
-
Measure voltage on the traction control signal wire at the TCM connector
-
Check for short to ground in the wiring between ABS module and TCM
-
Inspect connectors at both modules for corrosion
-
Verify ABS module output using a bidirectional scan tool
Sources 1
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)
Which Vehicles Commonly Get P0858?
- 2008-2018 Honda Accord
- 2010-2020 Hyundai Sonata
- 2007-2017 Nissan Altima
- 2009-2019 Kia Optima
Explore More
Was this helpful?
Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.