P0835 moderate

Clutch Pedal Switch B Circuit

The P0835 code means the vehicle's onboard diagnostic system has detected: Clutch Pedal Switch B Circuit. This is a moderate severity code.

My Garage →
Keep driving?
Short distances only
DIY difficulty
easy
Estimated cost
$20 - $150 (parts and labor)
Check Your Fluid First
ANCEL AD310 OBD-II Scanner

Read and clear transmission codes. Many trans codes are caused by low or burnt fluid -- check level and color before assuming the worst.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Read Transmission Codes
LAUNCH CRP123X (Reads All Systems)

Basic scanners only read engine codes. This reads transmission, ABS, and airbag too.

Check Price on Amazon

Affiliate link -- we earn a commission at no extra cost to you.

Common Symptoms

  • Check Engine Light illuminated
  • Cruise control may not disengage when clutch is pressed
  • Engine start interlock may not function properly
  • Clutch-related safety features disabled

Probable Causes (Ranked by Likelihood)

  • Faulty clutch pedal switch B Very High
  • Misadjusted switch B position High
  • Wiring fault in switch B circuit Moderate
  • PCM or BCM input circuit failure Low

Step-by-Step Diagnostic Procedure

  1. Locate clutch pedal switch B and test with a multimeter

  2. Verify switch B position and adjust if needed

  3. Inspect wiring between switch B and the PCM or BCM

  4. Compare switch A and switch B signals on a scan tool to identify which is faulty

Frequently Asked Questions

What is the difference between switch A and switch B?

Switch A and switch B are redundant clutch pedal switches. They serve different but overlapping functions, such as starter interlock, cruise control disable, and shift interlock. Two switches provide redundancy for safety.

Can both switches fail at the same time?

It is uncommon but possible if a shared connector or wiring harness is damaged. If both P0830 and P0835 appear together, check the common wiring and connector first.

Is switch B easy to access?

Yes, like switch A, switch B is located at the clutch pedal bracket area under the dashboard and is usually accessible without removing any panels.

Sources

This page is built from documented references. Verify against your own service info before repair work.

Explore More

Was this helpful?

Share carcodefinder.com with a friend who needs to decode their check engine light.